Full Face Respirator Fuel Masks, Fuel Masks Survival Nuclear and Chemical with Activated Carbon Filter

Perfect
This is a great help in the shop, saves a poorly fitting pair of goggles combined with a respirator and face shield, 3 in one, great investment!

Some stuff to know getting started
This comes with two configurations of filters. The first are flat, round, purple/pink filters that are labelled “Particulate Filter, P1000 with nuisance level organic vapor relief”. These have a maximum use time of 40 hours, or should be discarded 30 days after opening the package. The second configuration is what you see in the image connected to the mask labelled “6001CN”. These are primarily for organic vapors, but also have several replaceable cotton pads labelled “5N11 NIOSH N95 21J2060 (appears to be authentic but haven’t tested). They do not have a maximum use time or expiry date noted, but 6001 filters typically have a shelf life of 6 months once opened and 5 years unopened. 3M’s suggestion as to use time is vague, suggesting to simply replace them either after 6 months of use or when they become noticeably clogged/difficult to breathe through.Inside of the mask there is a rubber piece that is shaped like a normal dust mask. This piece didn’t seal to my face. It appears to be basically a funnel for your breathe toward the one-way valve, fine to use the mask without but you might encounter fogging (I notice some moisture accumulation while using it this way, but not actual fogging). The lens is NOT dual-pane, so it will fog outdoors unless you use an anti-fog coating (which you shouldn’t do on full face masks because you’ll end up inhaling it).There is a protective film on the outside of the mask shield that is meant to be removed. It’s a little difficult to get started but comes right off once you get a corner up.The seal around the mask itself works great as long as you synch the straps down.When installing either of the filter options, take note that two of the locking lugs on the mask are large and one is small, then look at the mating face on the filter. You need to push them on to the locking lugs in the correct orientation, push inward a bit toward the mask to compress the gasket, and then rotate clockwise to lock them into place. To remove, press inward a bit and rotate counter-clockwise to remove. If you don’t pay attention here, the locking lugs on the mask might break.

Great product
Great mask. Works great

Mask Face Shield is full of bubbles. Hard to See Through
Not only was the retail box damaged but when I went to assemble mask I noticed what looked like something got sprayed on the clear plastic shield. little spots all over shield. Treid glasse cleaner and then realized it was defectively made and the plastic is not clear. Full of little circular spots.Visiblity greatly hampered. One I wear every day or pollen is clearer than brand new GARBAGEDON’t waste your money.